Metallics
Product: Digo Metallics is a decorative plaster for indoor and outdoor use, consisting of coated natural stone grains, transparent, alkali-resistant, plasticizer-free and non-saponifiable acrylic dispersions.
Specific use: Digo Metallics is suitable for any sound and level surface on indoor and outdoor ceilings and walls including concrete, chipboard, gypsum board and fixed coats of paint.
Characteristics: Digo Metallics is weather and water-resistant, optimally breathing, elastic, scratch-, crack- and shrink resistant, has good adhesion and is easy to apply.
Water absorption (KWA): [ kg/ (m2*-t) ] 1.46
Permeability (WDD): [ g/ (m2*d) ] 176.3
SD: [m] 0.1
Colour: Available in standard colours. Various lots can show small differences in colour, caused by the production process, and the mineral origin of the natural stone grain. In order to prevent colour differences, it is advised to order the total quantity required for a project. Always mix different lots with each other.
Processing temperature: Do not use at a surface and ambient temperature below + 5°C.
Method of application: Digo Metallics is applied with a stainless steel trowel evenly and amply on grain thickness. Dependent on the circumstances after some drying. After ( ± ½ - 1 hour), plaster the applied material with a clean wet stainless steel trowel. When plastering too long and/or too hard, the stainless steel trowel can cause dark stains.
Consumption: Digo Metallics fine (1 mm ) ± 2.8 kg per m2.
Packing/Contents: Digo Metallics fine in plastic buckets of 7 and 15 kg.
Surface: Pre-treat the surfaces using Ruwer. See separate product information sheet. The surface must be dry and free from dust, grease and powdery coats of paint (wipe-resistant, whitewash coats). Powdery surfaces must be pre-treated with Diepgrondering ov. See separate product information sheet before applying Ruwer.
Storage: Protect against heat and frost.
Remark: Clean with water-diluted detergent, (do not use aggressive cleaning agents or solvents). Digo decorative plasters must always be applied with stainless steel tools. In the case of strong wind and bright sunlight, precautions against fast drying must be taken.
6c (6-2016)
Overzicht Metallics stalen
Although the utmost attention has been paid to the accuracy of the colors, can not be guaranteed that every steel fully corresponds to the original materials. There may be colour deviations result from:
a the printing process
b different structures
c variations in natural raw materials
d your screen settings.